Atlas Copco C200 TS-14 Euro 5 AdBlue SCR Removal Emulator

The Atlas Copco C200 TS-14 mobile compressor and power unit runs extended shifts under full load at mining, drilling, and construction sites where a sudden loss of air output can halt an entire operation. In these demanding environments the Euro 5 SCR system is exposed to urea dosing irregularities, NOx sensor drift, and DEF quality warnings that progressively throttle engine output and eventually force the unit into limp mode. At a remote site, a compressor running at reduced capacity can idle downstream equipment for days before a service crew arrives. The Atlas Copco C200 TS-14 Euro 5 AdBlue (SCR) Removal Emulator cuts this failure chain permanently at the electronic level, keeping the unit at full rated output regardless of SCR system condition.

How Does It Work?

The emulator seats directly onto the factory connector leading to the engine control module — no cables are cut and no soldering is performed. While active it produces upstream and downstream NOx readings, urea dosing pump feedback, and SCR catalyst efficiency signals continuously within the bands the control module expects. The module reads the system as fault-free, raises no DTC codes, and does not engage power restriction mode. Removing the emulator returns the unit to its factory configuration.